Wednesday, January 29, 2014

Replacing the Standard Remote Switches for Patio Lights, Water Heater, and Inverter to Illuminated Switches

Roadtrek remote switches for the water heater, inverter/charger, and the patio lights has no light illumination visually reminding the user that it is on, one could easily forget to turn them off and waste valuable resources.

Rather than installing an indicator light next to the switches, I opted for illuminated switches which should be easier to install. The hard part is finding a correct size switch replacement. The original switches dimensions are as follows: 21 mm (W) x 26.11 mm (L).

Picture below shows the newly installed illuminated switches.

Saturday, January 4, 2014

Replacing the Propane Regulator in Agile

This article is not intended to qualify anyone to work on a propane system. Propane when improperly handled can be very dangerous and should always be treated with the utmost respect. If there is ever a concern about a propane system, a qualified technician should check it out as soon as possible.

The propane regulator is the heart of the propane system, if it fails, appliances that uses propane as fuel will no longer work and that can be a major headache for anyone dry camping. Leaking at the propane regulator is one of the major regulator failures. If you noticed a propane leak in the system, it is highly advised to shut the propane flow at the service valve to prevent further leaking that can/ may result in disastrous situations.

Agile has a two-stage horizontal mount propane regulator and a single high pressure regulator feeding the outdoor pig tail that is located on the passenger side rear wheel well area. The propane regulator is mounted on the propane tank towards the rear end and can only be accessed under the RV.

I highly recommend that a qualified propane technician do the propane regulator replacement. If you are out camping and needed to change the propane regulator, you are doing so at your own risk. This article is only intended to familiarize you with the propane regulator in RT Agile and not intended to qualify anyone to work on propane system.

Before you start, make sure to close the propane service valve.

1. Disconnect the propane pigtail hose from the propane service port. The thread on the pigtail (P.O.L end) is reversed as marked with the indentation on the P.O.L nut; turn clockwise to loosen from the service valve outlet port.